Wholesale Replacement Vacuum Pump Oil Mist Separator Filter Busch 0532140154 Filter

Tips：Because there are more 100,000 types of air compressor filter elements, there may be no way to show one by one on the website, please email or phone us if you need it.

Vacuum pump oil mist separator purification efficiency is high ‌, the main reasons include its efficient filtration efficiency and high temperature resistance. This equipment can effectively reduce or eliminate the large reduction of vacuum pump oil, improve the cleanliness of indoor and factory buildings, and reduce environmental pollution. Its characteristics of high filtration efficiency, small size, long life, high temperature resistance, good oil removal and purification effect, low pressure difference, easy operation, etc., make the vacuum pump oil recycling, no oil smoke, clean and environmental protection, thus saving the use of oil. In addition, the vacuum pump oil mist separator also has a price advantage, which is more convenient to buy, and further improves its cost performance and practicality in practical applications. ‌

‌vacuum pump oil mist separator filter element installation steps:

1. Ensure safe operation: Before installation, first ensure that the mechanical pump has been turned off and locked to avoid accidental start-up. At the same time, before disconnecting the pipeline or air intake, ensure that the pipeline is connected to the atmosphere and release the internal pressure ‌.

2. Prepare the new filter cartridge : Ensure that the new exhaust filter is equipped with a new O-ring, this is an important step to ensure the tightness ‌.

3. Install the filter element : Install the exhaust filter and ensure that its port is correctly installed in the specified position of the oil mist separation box. Adjust the screw in the middle of the exhaust filter spring so that the top protrudes from the spring approximately 2-5 turns ‌.

4. Fix the filter element : Install the exhaust filter spring using a special tool, ensure that its tail is fixed to the socket in the oil mist separation tank, and install the screw in the groove of the exhaust filter ‌.

5. Tighten and check : Tighten the screws on the exhaust filter spring so that the nut fits tightly into the steel sheet of the spring. Check that the sealing gasket under the exhaust bearing end cap is clean and intact. If damaged, replace it with ‌.

6. Complete the installation : Install the exhaust bearing end cover with sealing gasket, and the hexagon bolts and sealing rings on the oil mist separation tank. Connect the exhaust pipe to if necessary.

Through the above steps, you can ensure the correct installation of the vacuum pump oil mist separator filter element, so as to ensure the effective operation of the vacuum pump system and extend the service life of the equipment.