The removal method of vacuum pump oil mist filter is explained in detail

First, remove the vacuum pump filter element

1. Prepare tools such as a ruler, wrench, and spare filter element.

2. Remove the short connector of the pump head and take out the filter.

3. Put the filter on the operating table, use a ruler and wrench, find the hole at the bottom of the filter, turn it upward and pull out the filter element.

4. Gently clean the outer surface of the filter element with a brush, and blow out the impurities inside with compressed air.

Second, clean the atomizer

1. Remove the atomizer from the oil pump and remove the long connector of the atomizer.

2. Soak the nebulizer in the washing solution for about 30 minutes, and then gently scrub the inner and outer surfaces of the nebulizer with a brush.

3. Dry the atomizer with compressed air and then reinstall it to the oil pump.

Three, replace the sealing ring

1. Remove the long connector of the pump head and remove the sealing ring.

2. Install the new sealing ring, and then reinstall the long connector.

3. Check whether the pump head, filter and atomizer are assembled correctly, and then restart the vacuum pump for testing.

真空泵滤芯件号_副本

The disassembly method of vacuum pump oil mist filter is relatively simple, just prepare the tools and follow the steps to operate. It should be noted that care should be taken when disassembling to avoid damaging the internal structure of the pump oil mist filter. At the same time, the filter element and atomizer can be cleaned and replaced each time they are disassembled to ensure the normal use of the pump oil mist filter and extend its service life.

We are a manufacturer of filtration products. We can produce standard filter cartridges or customize various sizes to suit various industries and equipment.Because there are more 100,000 types of air compressor filter elements, there may be no way to show one by one on the website, please email or phone us if you need it.

initpintu_副本(2)


Post time: Dec-12-2024